Energy UNITS FOR LIFT TABLE 1
Basic Description
This energy unit is built exclusively for that smaller lift table,Consisting of large strain gear pump, AC motor, multi-functional manifold, valves, tank, etc. This energy unit has become extensively made use of within the business of logistic products for instance minifork lift, scissors lift and ariel operating platforms. The lower-ing motion is managed by the solenoid valve together with the pace managed from the adjustable needle valve.
Energy UNITS FOR LIFT TABLE two
General Description
This power unit is created exclusively for your medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion is actived through the solenoid valve along with the speed controlled by the adjustable needle valve. Once the lift rises to a large positoin, however the electrical power supply is lower, the decreasing motion is controlled through the manual override function.
Electrical power UNITS FOR LIFT TABLE three
General Description
This electrical power unit is designed solely for the huge lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived from the solenoid valve as well as pace controlled by a strain compensated movement control valve.
Electrical power UNITS FOR LIFT TABLE 4
Basic Description
This electrical power unit is built solely for the massive lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived through the solenoid valve as well as speed controlled by the adjustable needle valve. Once the lift rises to a large positoin, but the electrical power provide is minimize, the reducing motion is managed by the guide override perform.
Distinctive Notes
one. This electrical power unit is of S3 duty cycle, which might only work intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean all the hydraulic parts concerned ahead of installation of the electrical power unit.
three. Viscosity of your oil shoud be 15~46 cst,which should also be clean and absolutely free of impurities.N46 hydraulic oil is encouraged.
four. Oil modifying is required following the preliminary a hundred operation hours,afterwards the moment each and every 3000 hrs.
5. The electrical power unit proven is intended to be mounted vertically.