C Variety Flex-Flex Couplings
The C Form coupling includes two flex hubs, one sleeve and one accessory kit consisting of seals and snap rings.
CFR Type Flex-Rigid Couplings
The CFR Type coupling consist of one particular flex hub, a single rigid hub, one 
particular sleeve, 1 accessory kit consisting of seals and snap rings.
Options
Basic and reasonably priced type of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in place
Out there as vertical and horizontal couplings
Wide assortment of specific variations like full-flex, flex-rigid mill motor
Standard configurations can be found from the shelf
Ordering Information
Application: Driver and Driven.
Style and size of coupling, horizontal, vertical and so on.
Power: Motor horspower or torque requirement.
Velocity: Motor RPM or Driven RPM.
Distance amongst shaft ends (BSE).
Shaft sizes.
C and CFR Type Couplings
Ordering Data
Puller Holes are typical on sizes 4 by 12.
Puller Holes can be found for sizes 7/8 as a result of 3.5 at an additional charge.
The BSE (distance Concerning Shaft Ends) might vary involving G and G1.
Interference bores with no set screws are common except if otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, check with Engineering Part.
More substantial sizes are available, please seek advice from Technical Assistance.
