Material Managing Power UNIT one
This electrical power unit is made for the fork lift market, consisting of very efficient gear pump, DC motor, manual raise and lower valve, tank, ect. The up and down movement are managed through the lever of your manual release valve, that is equipped with an electric switch to activate the motor. The lowing velocity is controlled through the stress compensated flow manage valve.
1. The duty of this power unit is S3, i.e. thirty seconds on and 270 senconds off.
two. Clean all the hydraulic elements concerned before set up of the energy unit.
three. Viscosity of your hydraulic oil shoud be 15~46 cst, which must also be clean and free of impurities, N46 hydraulic oil is advised .
4. Oil changing is needed after the preliminary 100 operation hrs, afterwards when just about every 3000 hours.
five. The electrical power unit proven is built to be mounted horizontally.
Material Managing Energy UNIT two
This electrical power unit capabilities energy up gravity down circuit. Activate the get started solenoid to start out the motor to lift the machine. The lowing movement is activated by the solenoid valve using the reducing speed managed through the strain compensated flow manage valve. Items of this series is usually extensively used in the market of logistic devices like fork lift, mini lift table, and so on.
one. The duty of this power unit is S3,i.e.,30 seconds on and 270 senconds off.
2. Clean all the hydraulic parts concerned in advance of mounting the electrical power unit.
three. Viscosity in the hydraulic oil shoud be 15~46 cst,which should really also be clean and cost-free of impurities, N46 hydraulic oil is proposed .
4. Oil changing is needed right after the original one hundred operation hours,afterwards once just about every 3000 hours.
5. The electrical power unit ought to be mounted horizontally.